When construction or remodeling wraps up, everything might look brand new—until you check the windows. You’ll probably see dust, paint splatter, sticky labels, and even grout or adhesive stuck to the glass. That cloudy mess takes away from the clean look of your space.

If you're in Reno and just finished a project, this guide will walk you through how to properly clean your windows after construction. We'll cover what to do, what to avoid, and why hiring a construction cleanup service near me—like Prestige Building Maintenance of Nevada, LLC—can save you time and stress.

1. Start with a Careful Inspection

Before you begin cleaning, take a walk around the property and inspect each window:

Look for stickers or labels left by the manufacturer Check for paint splatters or caulk smudges Spot any scratches or damage early

This helps you plan out your cleaning process and avoid making any damage worse.

2. Dry Dust First, Always

Construction dust settles fast, especially on glass. But don’t spray cleaner and start wiping right away. Dry dust the windows first using a microfiber cloth or soft brush. Wiping dust with a wet rag can scratch the glass or smear dirt across the surface.

Pro Tip: Make sure to dust the window tracks and frames too—those areas collect just as much grime.

3. Tackle the Stickers and Tape

Most new windows come with labels, tape, or protection film that’s tough to remove after baking in the sun. To remove them:

Gently peel off what you can by hand Spray the sticky area with warm, soapy water or a commercial adhesive remover Let it soak for a few minutes Use a plastic scraper (never metal) to lift any stubborn pieces

Be patient—rushing this part can leave behind scratches or glue residue.

4. Remove Paint and Grout Spots

Accidental splatters from paint, caulk, or even grout are common after construction. To remove them:

Spray the affected area with warm water to loosen the spot Use a plastic razor blade at a 45-degree angle to gently scrape it off Wipe clean with a damp cloth

Avoid using sharp blades or abrasive pads. They can scratch the glass or damage window coatings.

5. Wash the Windows Thoroughly

Now that the major debris is gone, it’s time for a full clean:

Mix a window-safe cleaning solution (store-bought or a mix of vinegar and water) Use a soft cloth or sponge to wash the glass in small sections Wipe with a squeegee from top to bottom to avoid streaks Dry edges and corners with a lint-free towel

For hard-to-reach windows, use an extension pole—or better yet, call in the pros.

6. Clean the Frames and Tracks

Don’t forget the window frames and sills. They hold a lot of construction dust and can even jam if the tracks are filled with debris. Wipe them down with a damp cloth and vacuum the tracks if needed.

Why Hire a Construction Cleanup Service Near Me?

Let’s be honest—cleaning windows after construction is not easy. It takes time, patience, and the right tools. That’s why many Reno property owners trust Prestige Building Maintenance of Nevada, LLC to handle it for them.

A professional construction cleanup service near me can:

Safely remove stickers, paint, and dust without scratching glass Clean both interior and exterior windows Reach high or hard-to-access windows Leave your building looking move-in ready

Final Thoughts

Windows are one of the first things people notice when they walk into a new or renovated building. Dirty or scratched glass leaves a bad first impression—especially in commercial spaces.

By following these tips or hiring an experienced construction cleanup service near me, you’ll make sure your windows are spotless and crystal clear. So whether you're wrapping up a remodel, new build, or tenant improvement project in Reno, don't forget to give your windows the attention they deserve.

Prestige Building Maintenance of Nevada, LLC is here to help you see the difference—literally.